Boltex - Interior & exterior texture

Characteristics: Boltex is a quality texture emulsion paint reinforced with coarse-hard aggregates

Recommended Use: Recommended as a finish coat for interior and exterior surface of, plaster, concrete and masonry cement panel.

Physical Characteristics


Texture matt


White and stander color




1.72 kg/L


600000-800000 cp

Film Thickness
Wet film

600-800 micron


If thinning is necessary, thin up to a maximum Of 10% Water

Recommended Coats

Apply 2 coats to appropriately prepared substrate

Theoretical Coverage

3-4 m /L

Flash Point


Surface Preparation: ALL SURFACE TO BE CLEAN, dry. Remove all grease, oil, wax, or other Material by solvent or detergent washing. Remove all loose, flaking or chalking surfaces. New Construction: Dependent on yard procedures, consult your Eagle Representative.

Application Methods: Method: Brush, roller or spray

Drying: Dry time is approx.1/2 hour to be recoated after 2-3 hours full cure after 72 hours. The dry time will vary with temperature and humidity.

Packing: 18 kg package in pails or bags

Storage & Shelf-life: Minimum 12 months in closed container. Keep container in a well-ventilated area. Close container after each use. Keep lid tightly closed during storage. Protect from direct sunlight and heat. The applicator should obtain more detailed information from the product label.

Health & Safety: Avoid contacts with eyes. Wash hands after use. Please read and observe all precautionary notices on container labels.

DISCLAIMER: The technical data presented in this bulletin are based upon the best available data and practices known to Eagle Paints at the present time. Since Eagle Paints is constantly improving its coatings and paint formulas, future technical data may vary somewhat from what was available when this bulletin was printed. Please contact your Eagle Sales Representative for the most up-to date information. Your feedback is important to us. If you have any comments or suggestions regarding our products and services, please share them with us.

Product for application

  • 2 coat of emultex putty for interior or 2 coat of super emultex putty for exterior.
  • One or 2coat of boltex texture


Get in touch
Contact US