Eagle over Print for Can Coating

Characteristics: Eagle Over Print for Can Coating is based on special medium alkyd and melamine resin.

Recommended Use: Recommended as over print  for cans and pails.

Physical Characteristics

Finish

 Gloss

Colour

 Clear

Solid/volume

54.5%

Density

0.99 -1.02 kg/L

Viscosity

1.30 – 2.30 min

Film Thickness
Wet film

10 micron

Thinning

If thinning is necessary, thin up to a maximum Of 10% butyl glycol

Recommended Coats

Apply 2 coats to appropriately prepared substrate

Dry time

Must be in oven at 180 degree centigrade for 12 min.

Theoretical Coverage

100 m²/L 

Gloss @ 60

80 degree

Surface Preparation: All sheets to be clean and dry. Remove all grease, oil, wax, or other material.

Application Methods: Method: special equipment 

Drying: Dry time is approx 12 min. At oven for 180degree centigrade.  The drying time will vary with temperature.

Packing: drum 180 kg   

Storage & Shelf-life: Minimum 12 months in closed container. Keep container in a well-ventilated area. Close container after each use. Keep lid tightly closed during storage. Protect from direct sunlight and heat. The applicator should obtain more detailed information from the product label.
 
Health & Safety: Avoid contacts with eyes. Wash hands after use. Please read and observe all precautionary notices on container labels.

DISCLAIMER: The technical data presented in this bulletin are based upon the best available data and practices known to Eagle Paints at the present time. Since Eagle paints is constantly improving its coatings and paint formulas, future technical data may vary somewhat from what was available when this bulletin was printed. Please contact your Eagle Sales Representative for the most up-to date information. Your feedback is important to us. If you have any comments or suggestions regarding our products and services, please share them with us.

Product for application:

  1. One coat of eagle enamel can coating
  2. One coat of eagle over print
Get in touch
Contact US